E1.31(sACN) to DMX Interface/Bridge for Madrix,MagicQ, 4 DMX512 Universes output

Description

E1.31(sACN) to DMX Interface/Bridge for Madrix,MagicQ, 4 DMX512 Universes output
If you are not satisfied with your purchase, simply contact us via eBay message and your interests will be protected.
Please don't open a dispute or leave neutral/negative feedback without communication. Thanks.
Product Brief:
1.
E1.31(sCAN) to DMX Interface/Bridge,output up to 4DMX universes
2.
E1.31 to DMX over Ethernet in Multicast format,configurable via web browser
3.
One or more E1.31 to DMX Interfaces with different IP assigned can be used via a network(LAN) connection to achieve more DMX universes output
4.
Compatible with any software package that supports the E1.31(sCAN) protocol output ,for example,below software supports E1.31 protocol output and works with the E1.31 to DMX Interface,For software output setup,just select the E1.31/Scan/can output type,some softwares will need special plugin such as Vixen
5 Steps Quick Start Guide
Step 1
Check your package parcel and you will find one E1.31 to DMX Interface, one DC5V power supply, one RJ45 male to male CAT5 cable and 4 RJ45 to DMX output connectors. Besides, there's a small CD-ROM in package as a manual instruction for this interface.
Step 2
Connect the CAT5 cable between your computer's RJ45 Jack (ethernet port) and the interface's input port.
Step 3
Connect your DMX fixtures to the interface's output port.
Step 4
Connect the DC5V power supply with the interface. At initial power up, the 'DMX' LED indicator will flash 2 flashes and the 'WEB' LED indicator will turn on.
Step 5
Open your software application and select  the E1.31 , sACN or ACN output type. And the E1.31 to DMX is ready for use. Now you can play with your software and enjoy the interface!
The as-shipped default value of the interface is as below and can be changed / configured via a web browser by the configuration commands.
Default IP: 192.168.1.206
Default output DMX universe No.: RJ45 Jack 1 = Output DMX Universe 1; RJ45 Jack 2 = Output DMX Universe 2; RJ45 Jack 3 = Output DMX Universe 3; RJ45 Jack 4 = Output DMX Universe 4
PS: You can assign any universe number to any output RJ45 port via configuration web page, such as Universe 123 to RJ45 Jack 1, Universe 666 to RJ45 Jack 2, …
If you think above default value is good enough for your controlling system, that's it and here you go and play!
Parameter:
1.
Size:115*90*40mm
2.
Package Size:160*160*60mm
3.
G.W:370g
Package Included:
1 x E1.31(sCAN) to DMX Interface
1 x DC Regulated 5V power supply
1 x One meter length CAT5 ethernet cable
4 x RJ45 to DMX(XLR-3pin) connector